M2-4 Auto L Sealer

The in-feed section would accept input from a single conveyor onwhich the products would arrive in single lane after inspection. This inspectedproduct will transfer from inspection conveyor to the in-feed conveyor of themachine

2. Sealing and Film Feeding Section

The Shrink Wrapper uses one center folded roll of film. Rolls havegravity unwind with provision to feed out.

The sealing system comprises of a hot knife design with specialTeflon coated for P.E. films.

When product passes through the in-feed conveyor and reach tosealing area sensors senses the product and passes the signals to thepneumatically operated sealing bar. Therefore, the cylinder retracts andsealing jaw comes down. After the seal is made, it retracts. Cool air is thrownon the seal to achieve a strong seal. Once the sealing is over, the out-feedconveyor takes the product inside the Shrink Tunnel.

This will transfer the first set of loosely wrapped packs into thetunnel, where the shrinking process will take place, in this way the cyclecontinues.

]

Pneumatic Cylinders : Genetics

Sealing knife : Aluminum Alloy and Teflon coated

PLC. : Ceco / Schneider/Delta

Panel component : Schneider

Conveyor A.C. motors : Oriental or Equivalent

Unwinder/scrap motors : Oriental motors or Equivalent

Heaters : Encapsulated circulate Anupam make.

PID controllers : Udyan make

Sensors and proxy switches : Omron

Sealing Pad : Silicon rubber

Knife Guard : Teflon covered

Conveyor (Tunnel) : Rollers with Silicone sleeves.

Nuts & Bolts : SS.

Controls tunnel : Omron.

Heaters Tunnel : Finned Heaters

]MACHINESPECIFICATIONS:

Product dimension (max) : 510[L] x380[W]x 130 [H] mm.

Power : 440V, 3 Phase, 50Hz, 5.5 KW

Air : 95 PSI at 6Lit./Sec. (12.7C.F.M)

Max. No. of packs/min. : Max 18-20 Packs/Min.